Ink cleaner 3#

一、 Product introduction

In the circuit board screen printing line ink and solder proof ink, with the accumulation of time, the ink on the screen frame is more and more accumulated. This ink layer can not be removed by white water or acetone. If mechanical methods such as knife scraping or friction can not be removed, clean 3. Mesh frame cleaning agent is our latest developed special solvent for cleaning mesh frame. It can be used to clean all kinds of metal mesh frame without damaging metal on the surface of mesh frame. It has the advantages of short soaking time, time and labor saving, small odor, easy cleaning, no heating and energy waste.

二、 Product characteristics

1. Appearance: colorless transparent liquid

2. Specific gravity: 1.1-1.5

3. Flash point: > 200 ℃

4.PH＜4

三、 How to use it

1. Clean the tank and add 100% cleaner 3 solution at room temperature

2. Put it directly into the mesh frame and soak it for 10-30 minutes (adjust it according to the ink thickness on the screen frame surface)

3. After wiping with rags or brushes, rinse with water.

4. Add: when the mesh frame cleaning agent is taken out and the working tank liquid level is reduced, the liquid level must be replenished

5. Change slot frequency: according to the screen plate cleaning time extended up to 2 ~ 3 hours or due to excessive ink deposition, it is necessary to change the slot. Generally, 1 tank can

Clean 1000-3000 mesh frames.

6. Ventilation: required, and the operating environment is open and ventilated

四、 Tank material requirements

1. Stainless steel 316 or 304

2. Teflon

3. Titanium

4. Special PP material

5、 Storage

Store in a cool, ventilated and shaded place